Promise Technology SmartStor DS4600 - Replacing the Power Supply; Removing the Power Supply

SmartStor DS4600 Product Manual
132
Replacing the Power Supply
The SmartStor DS4600 uses the following power supply:
• Make and model: Edac EA11003E
• Input: 100 to 240 V, 2.5 A, 50-60 Hz
• Output: 12V, 8.33A max. through a DIN 22, 4-pin connector
Removing the Power Supply
To remove the old power supply:
1. Shut down the SmartStor.
See “Shutting Down the SmartStor” on page 35.
2. Unplug the power cord.
3. Turn the SmartStor enclosure upside down.
4. Press the two latches on the underside of the enclosure, release and remove
the cover.
5.
6. Press the power supply retainer back, slide the power supply forward and lift
the power supply out of its cradle.
7. Unplug the motherboard power connector.
Important
If your SmartStor is still under warranty, contact Technical Support
for repair under RMA. See page 116.
Latches
Feet (4)
Bottom of
enclosure