Appendix A: Maintenance
129
Hard Booting the SmartStor
To hard reboot the SmartStor:
1. Disconnect the power cable from the SmartStor.
See page 130, Figure 1.
2. Wait 10 seconds, then reconnect the power cable.
3. Press the Power button.
It takes about a minute to boot the SmartStor. When fully booted:
• The buzzer beeps one time.
• The System Status LED turns blue.
4. Verify that the SmartStor now appears in SmartNAVI Main Window.
Caution
Do not disconnect the power to reboot the SmartStor unless the
SmartStor failed to reboot itself after the firmware update.
To Next Page
Loading...
