Promise Technology SmartStor DS4600 - Connecting the Power; Installing the Software

Chapter 2: Installation and Setup
9
To connect the SmartStor to your PC via FireWire:
1. Attach the B connector of the FireWire cable to the FireWire connection on
the SmartStor. See page 6, Figure 2.
2. Attach the other end of the FireWire cable to PC.
Connecting the Power
To power the SmartStor:
1. Attach the power cord on the back of the SmartStor
enclosure and plug the other end into the power
source.
2. On the back of the SmartStor, press the power
button.
It takes about a minute to boot the SmartStor. When
fully booted:
• The buzzer beeps one time.
• The System Status LED turns blue.
Installing the Software
The SmartNAVI software connects your PC to the SmartStor, sets up the
SmartStor, sets up network drives on your PC, and performs backups.
• Installation: Windows (page 10)
• Installation: Mac (page 13)
Power Button
System Status LED