26
Storage
If you store the resistance meter for an extended period of time, it is recommended to charge the
Lithium-ion battery about every 6 months.
Storing the meter at -30°C to +60°C (-22 °F to +140 °F) is recommended.
Battery Replacement
WARNING
To prevent possible electrical shock, fire, or personal injury and for safe operation and
maintenance of the Product, read instructions below carefully.
Battery contain hazardous chemicals that can cause burns or explode. If exposure to chemicals
occurs, clean with water and get medical aid.
Use only the Prostat 801B-012 as a replacement battery.
Do not disassemble the battery.
Repair the product before use if the battery leaks.
Use only Prostat approved power adapters to charge the battery.
Do not disassemble or crush battery cells and battery packs.
Do not keep cells or batteries in a container where the terminals can be shorted.
Do not put battery cells and battery packs near heat or fire.
Do not put in sunlight.
To replace the battery pack:
Turn off the resistance meter.
Remove all probes and test leads.
Unlock the battery cover.
Lift the battery cover and remove it from the resistance meter.
Lift one side of the battery pack and disconnect the connector from the meter.
Install a good battery pack.
Place the battery cover into position and lock.
Note: Warranty on the battery pack limited to a defective battery pack and excludes normal end of
life of the battery. The warranty does not cover defects that are caused by normal wear and tear,
inadequate maintenance, insufficient ventilation, transportation, storage or faulty repair, misuse,
neglect, accident or abuse, modification to the battery pack.
To Next Page
Loading...
