Prostat PRS-801B - Page 5

3
 To avoid electric shock, never touch the inside of this apparatus. Only a qualified technician
should open this apparatus.
 Do not drop or strike the product. If the product is damaged, contact a Prostat Authorized Service
Center.
 This equipment is intended for use in electrostatic processes that are free from water, oil, solvent
and other conductive contaminants. Exposure to such contaminants will cause failure of the
electrical insulation system in the product
 This equipment may require proper grounding for accurate measurement in certain ranges.
 This equipment may get damaged if dropped. In such an event, it should be carefully
examined and any necessary repairs be made by an authorized technician.
 Do not exert any pressure on the LCD display from the top.
 In rare cases cleaning the PRS-801B, case and display with a slightly dampened cloth may be
required. Should this be required, use a very weak solution on of liquid soap and water. The cloth
should be barely damp. DO NOT allow the instrument to become wet with the cleaning solution.
 DO NOT allow cleaning solution to enter the unit through apparatus openings. Should the unit
become damaged with cleaning solutions, the warranty is voided.
 Do not expose this apparatus to dripping or splashing.
 Do not dispose of batteries in a fire.
 Do not short-circuit, disassemble, or overheat the batteries.
The Meter complies with:
Document
PRS-801B
PRS-812B
ESD TR53 Compliance Verification


ANSI/ESD S1.1 Wrist Straps


ANSI/ESD S4.1 Worksurfaces


ANSI/ESD STM9.1 Footwear


ANSI/ESD SP10.1 Automated Handling Equipment


ANSI/ESD STM11.12 Volume Resistance


ANSI/ESD STM12.1 Seating


ANSI/ESD S20.20


ANSI/ESD STM2.1 Garments


ANSI/ESD S7.1 Floor Materials


ANSI/ESD SP9.2 Foot Grounders


ANSI/ESD STM11.11 Surface Resistance


ANSI/ESD STM11.13 Two-Point Resistance


ANSI/ESD S13.1 Soldering Tools

