Proteco Q80S - Page 14

13 Q80S_2014
PROTECO S.r.l. Via Neive, 77 - 12050 Castagnito (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 info@proteco.net - www.proteco.net
Deleting ALL stored radio codes
1 Use buttons to move inside the menu, till the display shows:
2 Press and hold button for about 10 seconds till the display shows
3 Release button , control unit returns to stand-by
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit
Saving a new radio code for the 2ND RADIO CHANNEL
AUX optional radio module is needed to get a 2nd Radio Channel
1 Use buttons to move inside the menu, till the display shows:
2 Now press and hold the remote control and simultaneously press button
on the control panel.
The display shows the radio code position
3 If the display shows
It means that memory is full and no further code can be stored.
Repeat steps 1) and 2) to save another remote control for the 2ND RADIO CHANNEL
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit
(max)
Deleting an existing remote control code
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm
3 Use buttons to select the position of the code you want to delete
4 Press and hold button for about 5 seconds till the display shows
5 Release button , control unit returns to stand-by
Repeat steps 1) to 5) to delete other existing remote control codes
6 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit
.......
...