7
2.4 Front panel button description:
z "Mode": When pressed displays the modulation option
menus.
z "Config": This key when pressed selects the B OUT put,
Frequency Counter and RS232 menus.
z "Trig": When Burst, ASK, PSK or FSK modulation has
been selected (see chapter on the Trigger
functions), pressing the “Trig” key, the generator
enters the Single trigger mode. Pressing the Trig
key again the generator will output one
waveform.
The External trigger input is also enabled. A
signal applied to the External trigger input will
externally trigger the generator at the rate of the
External input signal.
z "Enter: Enters and stores the numeric data which has
been entered from the Key board or the rotary
dial
z "Esc: cancels the current keyboard or rotary dial data
operation and displays the data that was
previously entered. If the triggered operation was
previously selected, pressing this key will return
the unit to normal operation.
z Keyboard buttonsf enters data values in to the upper
portion of the display of the selected waveform
parameter. Pressing the ENTER key enters the new
data. If the data entered is incorrect, pressing the
To Next Page
Loading...
Need help?
General
