Protemp PT-75T-KFA - User Manual

32 pages

Save Page as PDF

To Next Page

Model Numbers

PT- 45-KFA / PT-70T-KFA / PT-75T-KFA / PT-125T-KFA / PT-175T-KFA / PT-215T-KFA

668 Stony Hill Road #302 Yardley, PA 19067 USA • Toll Free (800)-641-6996

Fax: (215)-891-8461 • Web: www.protemp.us • Email: info@pinnacleint.com

User’s Manual &

Operating Instructions

CONSUMER: READ AND SAVE THESE INSTRUCTIONS

701000129-15

GENERAL HAZARD WARNING:

READ AND UNDERSTAND ALL OF THE INSTRUCTIONS IN THIS MANUAL

BEFORE ASSEMBLING, STARTING, OR SERVICING THE HEATER. Be sure to comply with the

instructions and warnings provided with this heater. Failure to comply can result in fire or explosion

that can cause property loss, bodily injury, or loss of life. Only persons who can follow and

understand these instructions should operate or service this heater. If you need heater info; such as

an operating manual, labels, etcetera, contact Pinnacle Products International at 800-641-6996.

DANGER

NOT FOR USE IN RESIDENTIAL LIVING AREAS OR IN ENCLOSED SPACES

WITHOUT ADEQUATE VENTILATION. FOR OUTDOOR USE. INDOOR USE

PERMITTED ONLY FOR: THE TEMPORARY HEATING OF ADEQUATELY VENTILATED

BUILDINGS OR STRUCTURES UNDER CONSTRUCTION, ALTERATION OR REPAIR. This is

an unvented portable heater that uses air (Oxygen) from within the area in which it is used. Failure

to provide adequate combustion and ventilation air will result in asphyxiation, carbon monoxide

poisoning, bodily injury or death. Refer to “Ventilation” on Page 7.

DANGER

FACTORY ID: 001

Questions and Answers

S
Stacy OwenAug 6, 2025
What to do if Protemp PT-75T-KFA Heater doesn't operate and shows E1?
- M
  Michael BryanAug 6, 2025
  If your Protemp Heater doesn't operate, the motor runs briefly, the lamp flickers, and the LED displays 'E1', here are some things to check: 1. Ensure the fuel tank has fresh kerosene. 2. Adjust the pump pressure if it's incorrect. 3. Clean or replace a corroded spark plug with an incorrect gap. 4. Clean or replace the fuel filter if it is dirty. 5. Clean or replace the nozzle if it is dirty. 6. Rinse the fuel tank with fresh, clean kerosene if there's moisture inside. 7. Inspect all electrical connections between the transformer and circuit board. 8. Re-attach the ignitor wire to the spark plug if it's disconnected. 9. Replace the ignitor if it is defective.
K
Katherine JimenezAug 21, 2025
Why does my Protemp PT-75T-KFA Heater shut off after igniting and shows E1?
- H
  howardmariaAug 21, 2025
  If your Protemp Heater ignites but the main PCB shuts off shortly after, displaying 'E1' and the lamp flickers, it could be due to several reasons: * Incorrect pump pressure, which requires adjustment. * A dirty input, output, or lint filter, which should be cleaned or replaced. * A dirty fuel filter, which should be cleaned or replaced. * A dirty nozzle, which should be cleaned or replaced. * A dirty photocell lens, which should be cleaned or replaced. * Improper installation or a defect in the photocell, requiring adjustment, or replacement. * Improper electrical connection between the main PCB and photocell; check wiring connections.