Proxim Tsunami 8000 series User Manual

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 116
Roaming Preferred
Channels
Each BSU on the network, maintains a list of channels where its neighbour BSUs are operating.
When roaming is enabled, SU learns this list from the current BSU and uses it as Roaming
Channel List (RCL), to reduce scanning time while searching for a BSU with better Rx SNR.
To add channels, click Add under Roaming Preferred Channels. The Roaming Channel
Add Entry screen appears:
Figure 5-40 Add Channels to the Roaming Table
Do the following:
·
Channel: Select the channel of the neighbouring BSU, where the SU is likely to
roam.
·
Entry Status: If the entry status is enabled, then this channel is allowed to be
scanned by a roaming SU.
·
Next, click Add.
Figure 5-41 Channels Added to the Roaming Table
At any point of time, the channels and their corresponding entry status can be edited. You can
change the entry status to either,
·
Enable: Allows a roaming SU to scan a channel.
·
Disable: Does not allow a roaming SU to scan a channel.
·
Delete: Allows to delete a channel from the table.
Click OK and then COMMIT, if the table entries are re-configured.
: A maximum of five channels can be added to the Roaming Preferred Channels Table.
Parameter Description

Proxim Tsunami 8000 series Specifications

General

Brand	Proxim
Model	Tsunami 8000 series
Category	Network Router
Language	English