Tsunami
®
800 & 8000 Series - Software Management Guide 52
: IPv6 address is supported only in bridge mode.
5.2.1.1 Bridge Mode
5.2.1.1.1 IP Configuration (IPv4 Only)
To configure the IP parameters of the device when operating in Bridge mode, navigate to ADVANCED CONFIGURATION >
Network > IP Configuration. The following IP Configuration screen appears:
Figure 5-4 IPv4 Configuration (Bridge Mode)
Given below is the table which explains the method to configure IP parameters in Bridge mode:
Parameter Description
IP Mode Represents the IP Mode of the device. The IP Mode can be set to either IPv4 Only or Dual
(IPv4 and IPv6). By default, IP Mode is set to IPv4 Only.
: A change in IP mode requires device reboot.
Ethernet (Please note that the number of Ethernet interfaces depend on your device.)
To Next Page
Loading...
