Tsunami
®
800 & 8000 Series - Software Management Guide 54
Figure 5-5 IPv6 Configuration (Bridge Mode)
Given below is the table which explains the method to configure IP parameters in Bridge mode:
Parameter Description
IP Mode Represents the IP Mode of the device. The IP Mode can be set to either IPv4 Only or Dual
(IPv4 and IPv6). By default, the IP Mode is set to IPv4 Only.
: A change in IP mode requires device reboot.
Ethernet (Please note that the number of Ethernet interfaces depend on your device.)
Link Local IP Address Link Local IP Address is an Internet protocol that is intended for communication within the
segment of a local network or point-to-point connection that a host is connected to.
During initial bootup, each system is assigned with a Link Local IP Address whose prefix is
fe80::../64. The Link Local IP Address is a read only parameter.