Tsunami
®
800 & 8000 Series - Software Management Guide 56
Figure 5-6 DNS Configuration (Bridge Mode)
5.2.1.2 Routing Mode
:
·
A device (BSU/SU) will act as a DHCP Client only when configured in Bridge Mode.
·
In Routing Mode,
¹
With PPPoE Client disabled, the device (BSU/SU) IP addresses are assigned only statically.
¹
With PPPoE Client enabled, the device (SU) IP addresses can be assigned both statically and dynamically. See
C { B B B
k z {
To configure the IP parameters of the device when operating in Routing mode, navigate to ADVANCED CONFIGURATION >
Network > IP Configuration. The IP Configuration screen appears:
Parameter Description
Primary and
Secondary IP Address
Represents the IP address of the Primary and Secondary DNS Server.
Primary and Secondary IP Address can be configured manually irrespective of the IP mode.
The DNS address obtained from the DHCP server (Dynamic mode) or from the router
advertisement (Auto Mode) is given preference over the manually configured IP Addresses.
The device lists all the IP addresses from DNS server configured manually or obtained from
DHCP server/ router advertisement and only top three DNS server IP addresses will be used.
To view the IP addresses refer
x } { {
.
: IPv4 addresses will be given preference over IPv6 addresses.
To Next Page
Loading...
Need help?
General
