Proxim Tsunami 8000 series User Manual

Advanced Configuration
Tsunami
®
800 & 8000 Series - Software Management Guide 58
5.2.1.2.1 DNS
To configure the IP parameters of the device when operating in Routing mode, navigate to ADVANCED CONFIGURATION >
Network > IP Configuration. The IP Configuration screen appears:
Figure 5-8 DNS Configuration (Routing Mode)
Subnet Mask Represents the subnet mask of the wireless interface.
By default, the static subnet mask is set to 255.255.255.0. You can manually change the
subnet mask.
Default Gateway IP Address
IP Address Represents the gateway IP address of the device.
By default, the Gateway IP address is set to 169.254.128.132. You can manually change
the gateway IP address.
DNS Proxy
DNS Proxy It is a read-only parameter, which is enabled by default.
When DNS Proxy is enabled along with the DHCP server, the device will serve its own
address as the Primary DNS address to the DHCP client on the Ethernet.
:
·
If the DNS request from the client is destined to the device’s interface address
then the device acts as a DNS Proxy.
·
DNS Proxy is configurable through CLI/SNMP.
·
When DNS Proxy is disabled, you need to configure the DNS settings manually
so that the end-to-end communication works properly.
Parameter Description

Proxim Tsunami 8000 series Specifications

General

Brand	Proxim
Model	Tsunami 8000 series
Category	Network Router
Language	English