Tsunami
®
800 & 8000 Series - Software Management Guide 59
: In routing mode, the Primary and Secondary IP Address cannot be configured as IPv6 addresses.
After configuring the required parameters, click OK, COMMIT and then REBOOT.
:
·
To obtain dynamic IP address of the SU over WORP,
·
Scenario 1: When BSU and SU are in Bridge Mode with DHCP Client enabled in SU, and if external DHCP
server is running behind BSU, then SU will get the IP Address over WORP.
·
Scenario 2: When BSU and SU are in Bridge mode with DHCP client enabled in SU, and if BSU has an
embedded DHCP server running on the wireless interface, then SU will get the IP address from BSU.
·
Scenario 3: When BSU is in Routing Mode and SU is in Bridge mode, and DHCP server is in a different
network than SU, then configure DHCP relay in BSU to get the IP for SU over WORP.
·
Scenario 4: When BSU is in Routing mode and SU in Bridge mode, and if BSU has an embedded DHCP server
running on the wireless interface, then SU will get the IP address from BSU.
5.2.1.3 Routing Mode with PPPoE Client Enabled
To configure the IP parameters of the device when configured in Routing mode with PPPoE client enabled, navigate to
ADVANCED CONFIGURATION > Network. The IP Configuration screen appears:
Parameter Description
Primary IP Address Represents the IP Address of the Primary DNS Server.
Secondary IP Address Represents the IP Address of the Secondary DNS Server.
To Next Page
Loading...
Need help?
General
