Tsunami
®
800 & 8000 Series - Software Management Guide 60
Figure 5-9 IP Configuration (Routing Mode with PPPoE Client Enabled)
Given below is the table which explains the method to configure IP parameters in Routing mode with PPPoE client enabled:
Parameter Description
Ethernet (Please note that the number of Ethernet interfaces depend on your device.)
IP Address Represents the IP address of the Ethernet interface.
By default, the static IP address for Ethernet1 is set to 169.254.128.132 and
169.254.129.132 for Ethernet2. You can manually change the IP address.
Subnet Mask Represents the subnet mask of the Ethernet interface.
By default, the static subnet mask is set to 255.255.255.0. You can manually change the
subnet mask.
To Next Page
Loading...
Need help?
General
