12 User’s / Programming Guide
1. Scan the bar code beside Intercharacter Delay = XX and lis-
ten for one short-high beep.
2. After the beep, scan the bar code beside 0 on the Digit Selec-
tion page and listen for one short-high beep.
3. Still at the Digit Selection page, scan the bar code for 5 (the
last argument in the command) and listen for two short
beeps.
Your PSC scanner does not have a distinct programming mode.
Instead, it automatically recognizes and reacts to the labels you scan.
If, for example, you scan INTERCHARACTER DELAY = XX and
then scan a normal data label, a normal tone is emitted in response to
the data label, and the programming command is ignored. No special
exit code is required to resume normal operations.
To Next Page
Loading...
