06656 21
HF External Trigger(-)
General Parameters
Intercharacter Delay
Certain terminals and computers require an intercharacter delay to
simulate the effects of keystroke delays. Choosing an intercharacter
delay causes the characters to be sent at the slower speed required by
the device to which you are interfacing.
GA No Intercharacter Delay
GB Intercharacter Delay = XXMEC
Interlabel delay allows user to program a delay between transmitted
labels.
GC No interlabel delay *@
GD Set interlabel delay 0-9.9 seconds
NOTE
To set Intercharacter Delay to other then zero, scan the
label below and then scan two separate digits from the
Digit Selection page (99 maximum).
NOTE
Intercharacter delay cannot exceed 99 milliseconds.
To Next Page
Loading...
