24 User’s / Programming Guide
BE Enable 4 Times Laser Redundancy
Laser Timeout
The scan beam will activate in response to a trigger pull. The beam
will automatically deactivate after a label is decoded. If a label is not
decoded., the scan beam will timeout and deactivate after several sec-
onds. Scan the following labels to control the length of the timeout.
Beeper Operation
Scan one of the options below to modify beeper operation.
AA Beeper Off
AB Beeper On; Volume Low
BH
Set Scan Beam *#@ Timeout
to 6 Seconds
BI
Set Scan Beam Timeout to 4
Seconds
BJ
Set Scan Beam Timeout to 2
Seconds
BO
Set Scan Beam Timeout to 1
Second
BW
Set Scan Beam Timeout to
½ Second
To Next Page
Loading...
