Pudu T300 - Cleaning Method

PUDU T300 Operation Guide
Version: V1.0.2 Operation Guide
36
nameplates labels and nameplates on the robot
are intact and clearly visible
8.2 Cleaning Method
Warning
Do not use water or any other liquid to clean the robot. Always make sure that the robot is kept dry.
Step 1 Press and hold the power switch for 3 seconds to ensure that the robot is powered
off.
Step 2 Wipe the robot surface with a clean cloth.
Step 3 Wipe the chassis, drive wheels, and auxiliary wheels with a clean cloth.
Note
 If the drive wheels or auxiliary wheels are entangled or stuck with debris, please place the
robot down on its side for cleaning. Keep the ground clean and tidy (a mat can be used) to avoid
scratches on the robot surface when placing the robot down on its side.
 If there are oil stains on the tray pad, take it out and wash it separately. Put back the tray pad
after it dries off completely.
Step 4 Clean the vision sensor, depth vision sensors, and Lidar with a clean cloth or
specialized lens cleanser.
Note
 In case of unexpected contamination, address it immediately to avoid blocking the sensor
and preventing the robot from working improperly.