CP10.241-60
CP-Series
24V, 200W, DC/DC CONVERTER
P R E L I M I N A R Y
14. FRONT SIDE AND USER ELEMENTS
Fig. 14-1 Front side
A
Input Terminals
(Quick-connect spring-clamp terminals)
+ Positive input
– Negative (return) input
PE (Protective Earth) input
B
Output Terminals
(Quick-connect spring-clamp terminals, two positive pins and three negative pins)
+ Positive output
– Negative (return) output
C
Output voltage potentiometer
Open the flap to adjust the output voltage. Factory set: 24.1V
D
DC-OK LED (green)
On, when the output voltage is >90% of the adjusted output voltage
E DC-OK Relay Contact
(Push-in terminals)
The DC-OK relay contact is synchronized with the DC-OK LED.
See chapter 8 for details.
May 2017 / Rev. 0.1 DS-QS10.241-60-EN preliminary
All parameters are typical values specified at 24V, 8.3A output, 110Vdc input, 25°C ambient and after a 5 minutes run-in time
unless otherwise noted.
www.pulspower.com Phone +49 89 9278 0 Germany
12/27
To Next Page
Loading...
