CP10.241-60
CP-Series
24V, 200W, DC/DC CONVERTER
P R E L I M I N A R Y
23. ACCESSORIES
23.1. ZM12.SIDE - SIDE MOUNTING BRACKET
This bracket is used to mount the power supply sideways with or without utilizing a DIN-Rail.
The two aluminum brackets and the black plastic slider of the unit have to be detached, so that the
steel brackets can be mounted.
For sideway DIN-rail mounting, the removed aluminum brackets and the black plastic slider need to be
mounted on the steel bracket.
Fig. 23-1
Side mounting without DIN-
rail brackets
Fig. 23-2
Side mounting with DIN-rail
brackets
Fig. 23-3
Mounting Dimensions
Side mounting bracket
Note:
The isometric picture shows a
unit with screw terminals
Note:
The isometric picture shows a
unit with screw terminals
May 2017 / Rev. 0.1 DS-QS10.241-60-EN preliminary
All parameters are typical values specified at 24V, 8.3A output, 110Vdc input, 25°C ambient and after a 5 minutes run-in time
unless otherwise noted.
www.pulspower.com Phone +49 89 9278 0 Germany
19/27
To Next Page
Loading...
