CP10.241-60
CP-Series
24V, 200W, DC/DC CONVERTER
P R E L I M I N A R Y
23.2. ZM4.WALL – WALL/PANEL MOUNT BRACKET
This bracket is used to mount the devices on a wall/panel without utilizing a DIN-Rail.
The bracket can be mounted without detaching the DIN-rail brackets.
Fig. 23-4 Isometric view Fig. 23-5 Isometric view Fig. 23-6 Isometric view
Fig. 23-7 Wall/panel mounting,
front view
Fig. 23-8 Hole pattern for wall
mounting
Fig. 23-9 Wall/panel mounting,
side view
Note:
The picture shows a unit with screw
terminals
Note:
The picture shows a unit with screw terminals
May 2017 / Rev. 0.1 DS-QS10.241-60-EN preliminary
All parameters are typical values specified at 24V, 8.3A output, 110Vdc input, 25°C ambient and after a 5 minutes run-in time
unless otherwise noted.
www.pulspower.com Phone +49 89 9278 0 Germany
20/27
To Next Page
Loading...
