EasyManua.ls Logo

Pulsar FXQ30 - Recommendations for Use; External Power Supply

Pulsar FXQ30
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Keep the battery out of the reach of children.
RECOMMENDATIONS FOR USE
The batteries should be partially charged (50 to 80 %) for long-term storage.
The battery is to be charged at an ambient temperature of 0°C to +35°C or the lifespan of the battery
will decrease significantly.
When using the battery at sub-zero ambient temperatures, the battery capacity decreases. This is
normal and not a defect.
Do not use the battery at temperatures outside the range of -25°C to +50С or it may reduce battery life.
The battery is short circuit protected. However, any situation that may cause short-circuiting should be
avoided.
EXTERNAL POWER SUPPLY
External power can be supplied from an external source, such as a Power Bank (5 V).
1. Connect the external power source to the USB Type-C connector (9) on the device.
2. The device will switch to draw power from the external source while the АPS5 battery will be gradually
recharged.
3. A battery icon will appear on the display showing the percentage charge level.
4. An icon will be displayed when the device is powered by an external power source and the АPS5
battery is not connected.
5. The device automatically switches to the APS 5 battery when the external power supply is disconnected.
Attention! Charging APS 5 batteries from an external source at temperatures below 0°C can reduce
battery life. When using external power, connect the Power Bank to the device only after it has been
turned on and working for at least several minutes.

Related product manuals