1. When the device is on, press and hold the ON/OFF (6) button for less than 3 seconds. The display goes
blank and the message Display Off.
2. Press the ON/OFF (6) button briefly to turn on the display.
3. When you press and hold the ON/OFF (6) button, the display shows the message Display Off with a
countdown. Holding the button down for the duration of the countdown will power the device off
completely.
DISPLAY CALIBRATION
The thermal imaging attachment is configured so that after it is being mounted onto an riflescope that
has been correctly configured, no adjustment of the aiming point is required. If your attachment has
been subjected to hard blow or has been dropped, you may check the impact point and adjust it
yourself if required, without having to return it to a service centre.
1. Press and hold the controller button (8) for 10 seconds to enter the display calibration mode – the
coordinates X=0; Y=0 will appear.
2. Rotate the controller ring (8) to move the display horizontally (X axis) and vertically (Y axis) so that the
point of impact moves to the centre of the aiming reticle of your riflescope.
3. Press the controller button (8) briefly to toggle between the X and Y coordinates.
4. The image shift range is +/-20 pixels for a horizontal axis (X axis) and +/-20 pixels for a vertical axis (Y
axis).
5. To exit the menu and save the settings, press and hold the controller button (8) for two seconds.
To Next Page
Loading...
