OPERATION
MOUNTING ATTACHMENT ON OPTICAL RIFLESCOPE
1. Remove the eyepiece cover (2).
2. Select the Ring Adapter (12) (sold separately) with the insert (11) of the required diameter depending
on the outer diameter of the lens of your riflescope (10) (see Table). The designation 42 mm / 50 mm /
56 mm in the name of the adapter means the lens diameter of the riflescope.
3. Screw together the Ring Adapter (12) and the attachment along the threads of the mounting
area (17) until it stops. Then untighten a little (no more than one turn) so that the lever (16) is on the
right side (see Figure).
4. Evenly tighten the screws (13) until the ball joint grips in the Ring Adapter (12).
5. Apply 2-3 strips of double-sided tape to the outer surface of the insert (11) of your choice.
6. Push the insert (11) of your choice into the Ring Adapter (12) until it stops.
7. Move the lever (16) to the OPEN position.
8. Before installing the Ring Adapter (12) onto the riflescope, it is recommended to degrease the lens body
of the riflescope (10).
To Next Page
Loading...
