9. Mount the Ring Adapter (12) with the insert (11) onto the lens of the daylight riflescope (10) as far as it
will go.
10. If the Ring Adaptor (12) with the insert (11) selected according to the table cannot be mounted onto the
lens (10), follow the steps below:
o Loosen the locking screw (14) with a 2mm Allen key.
o Untighten the screw (15) with a hex wrench (S = 4mm) until the Ring Adaptor with the insert can be
mounted onto the lens (10).
11. Move the lever (16) from its initial OPEN position to the CLOSE position.
12. Loosen the locking screw (14) with a 2mm Allen key, if it hasn’t been done before.
13. Tighten the screw (15) using a 4mm Allen key. The clamping force should be 1.5-2 Nm (use a torque
screwdriver) to ensure the lever is correctly tightened (16), while the Ring Adapter with the attachment
should not move relative to the body of the riflescope (10). If necessary, tighten or loosen the
screw (15) to operate the lever (16) in the best way possible.
14. Tighten the locking screw (14) as far as it will go.
15. Turn on the attachment by briefly pressing the ON/OFF (6) button.
16. Align the display center with the crosshairs of the reticle by tilting the attachment.
17. Align top and bottom display boundaries parallel to the horizontal axis of the riflescope by turning the
attachment clockwise or counterclockwise.
18. Having reached the best possible position of the attachment, tighten the two screws (13) until stop. The
clamping force should be 5-7.5 N·m (use a torque screwdriver to check).
Selection Table for Riflescope Inserts
To Next Page
Loading...
