• if your Pulsar device is not connected to your phone but it's already in the “My Devices” section, you
may use Wi-Fi to download update.
Is your firmware up to date?
Click here to check the latest firmware for your device.
USB CONNECTION
1. Connect one end of the USB cable to the device micro-USB port (9) and the other end to the port on
your computer.
2. Switch the device on with a short press of the ON/OFF (6) button (the computer will not detect the
device if it is switched off).
3. The device is detected by the computer automatically and no drivers need to be installed.
4. Two connection modes will appear on the display: Use as power and Use as memory card.
5. Rotate the controller ring (8) to select the connection mode.
6. Press the controller button (8) briefly to confirm the selection.
Use as power
To Next Page
Loading...
