EasyManua.ls Logo

Pulsar FXQ30 - Page 30

Pulsar FXQ30
41 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Video mode. Video Recording
1. The Video mode is activated when you turn on the device.
2. The icon and the remaining recording time in HH:MM (Hours:Minutes) format are displayed in the
upper left corner, for example, 5:12. In the status bar, the video recording status is displayed
continuously.
3. Press the REC (7) button briefly to start video recording.
4. When the video recording starts, the icon will disappear and the REC icon and timer in MM:SS
(Minutes:Seconds) format will appear.
5. Press the REC (7) button briefly to pause or resume video recording.
6. Press and hold the REC (7) button to stop video recording.
7. Video files are saved to the built-in memory card after the video recording has been stopped.
8. Switch between modes (Video-> Photo-> Video) with a long press of the REC (7) button.
Photo mode. Capturing a photo
1. Switch to Photo mode by pressing and holding the REC (7) button.
2. Press the REC (7) button briefly to take a photo. The image freezes for 0.5 sec while the photo is saved
to the internal memory.
Notes:
You can enter and navigate the menu during video recording.
The recorded videos and photos are saved to the built-in memory card of the device in the formats
img_xxx.jpg (photos) and video_xxx. mp4 (video) where xxx is a 3 digit counter.
The counter for multimedia files cannot be reset.
Attention!
The maximum duration of a recorded video file is five minutes. After this time expires, the video is
recorded to a new file.
The number of recorded files is limited by the capacity of the internal memory of the device.

Related product manuals