ww w.PyleUSA.com
15
REMOTE CONTROL
Replace Lithium Battery Cell
1. When the lithium cell battery becomes weak,
replace it as illustrated on the right.
2. Press and hold the movable block in the direction indicated by arrow 1.
At the same time, pull the cell holder out of the remote control in the direction
indicated by arrow 2.
3. Replace the old cell with a new one, making sure the (+) polarity is facing upward.
4. Re-insert the cell holder into the remote control.
- Cell leakage may cause damage to the remote control.
- Do not throw cells into as this may cause an explosion.
- Keep battery cells out of reach of children.
Remove Insulating Sheet
The remote control comes with an insulating
sheet attached to the underside of the remote
control, as illustrated on the right.
The remote control will not work until the
insulating sheet is removed.
Remote Control Operation
Position the emitting window of the remote
control toward the sensor window of the unit.
• The operation angle for front panel remote
control reception is about 30 degrees.
• The distance between the emitting window of
the remote control and the sensor window
of the unit should remain less 5 meters.
To Next Page
Loading...
Need help?
General
