22
SIDE RACKS *
It is possible to easily remove and clean the wire shelving placed in the wire grid and tray.
You can recover the wire shelving from screw channel by stretch down the edge of special
plug, like as shown. Then, you can recover with pull up to outward and lift up to from upper
tabs. Install after cleaning; process done in reverse order, rst the upper tabs set to boiler
rack, after that placed in a screw channel with stretching the special screw-earth channel
wings. (See Figure 14)
Figure 14
* Only available on some models.
CHANGING THE OVEN LAMP
Make sure that the electricity did not come from the device before performing this
operation.
The oven lamp has to comply to these features;
1. Resistant to heat,
2. Electric rate: 220-240V AC 50Hz
3. Electric power rate: 25W
To replace the lamp, proceed as follows (See Figue 15) ;
1. Glass on the outer casing (A) remove the counter-clockwise,
2. Remove the oven light bulb counter-clockwise,
3. Replace it with a new one,
4. Ret the glass on the outer casing,
5. Switch on the electric supply.
WARNING: Ensure that the appliance is switched off before changing the lamp to
avoid the possibility of electric shock.
To Next Page
Loading...
