Pi HSC816 Installation Manual - Revision Beta
This document and product are copyrighted and all rights are reserved.
The zone leds will flash fast to indicate that the zone has triggered
Enter a user code to cancel walk test or allow to time out after
Sms control functions:
These functions are only available if a QD Serial GPRS communicator is connected to the system.
Sms must start with 816 followed by a valid users 4 digit pin code.
The commands below are assuming a user pin code of 1234.
Function sms to be sent
Arm 816 1234 arm
Disarm 816 1234 disarm
Home1 arm 816 1234 h1arm
Home2 arm 816 1234 h2arm
Switch trigger 816 1234 #x where x = trigger number 1 to 10 (ten being a 0)
To Previous Page
Loading...
Need help?
General