4 – Managing Switches
Switch Data Window
59235-02 A 4-5
L
User Login Group
User Name Account name
Login Level Authority level
Super User Super user privileges enabled/disabled
UserAuthentication
Enabled
Enforcement of account names and authority (always
True)
Firmware Group
Firmware Version Active firmware version
Inactive Firmware Version This field does not apply to this switch
Pending Firmware Version Firmware version that will be activated at the next reset
PROM/Flasher Version PROM firmware version
Services Group
NTP Client Enabled Enabled or disabled. Allows for switches to synchronize
their time to a centralized server.
NTP Server Address The IP address of the centralized NTP server. Ethernet
connection to NTP server is required.
FDMI Enable Fabric Device Management Interface status. If enabled,
device information can be obtained, managed, and saved
through the fabric using Name Service Management
Server functions. QuickTools will report all FDMI informa-
tion reported by the entry switch, if FDMI is enabled on the
entry switch.
FDMI HBA Entry Limit Maximum number of HBAs that can be registered with a
switch.
Embedded GUI Enabled QuickTools web applet status. Enables or disables the
web applet on the switch.
Inactivity Timeout Number of minutes the switch waits before terminating an
idle command line interface session. Zero (0) disables the
time out threshold.
GUI Mgmt Enabled Web applet status. If disabled, the switch cannot be man-
aged using the web applet.
Telnet Enabled Telnet client status
Table 4-1. Switch Data Window Entries (Continued)
Entry Description
To Next Page
Loading...
Need help?
General
