QNAP SAS JBOD CLI 1.0 - Route Table Read; Display Info for All Physical Layers

Route Table Read
Description
Display the default route and the routes for specific destination addresses.
Command
rtr
Syntax
rtr [d | z | dz]
Parameters
Parameter/Value Description
None Display enabled routes with a non-zero SAS address.
d
Display disabled routes.
z
Display routes with no SAS address.
dz
Display all routes.
Examples
The following example shows the default output.
Display Info for All Physical Layers
Description
Display information about physical layers.
Command
phyinfo
Syntax
phyinfo [help | edfb | power | up | cable | <phynum>]
Parameters
Parameter/Value Description
None Display the default output.
Command-Line Interface User Guide
Conventions and CLI Commands 9