QNAP SAS JBOD CLI 1.0 - Link Rate Control

Command
link
Examples
Link Rate Control
Description
Set the highest and lowest speed of a physical layer.
Syntax
link {<phynumber> <maximum speed> <minimum speed>}
Parameters
Parameter/Value Description
<phynumber>
Specify the the physical layer number.
<maximum speed>
Set the maximum speed.
Note
You can set speeds to 3, 6, or 12.
<minimum speed>
Set the minimum speed.
Note
You can set speeds to 3, 6, or 12.
Examples
The following example sets phy 0 to a maximum and minimum speed of six and three.
Command-Line Interface User Guide
Conventions and CLI Commands 12