2. Accessing the CLI from a Terminal Emulator
For Windows, you must use a terminal emulator to access the CLI. For macOS and Linux, you can use the
Terminal. QNAP uses Tera Term, an open-source terminal emulator for Windows, for this User Guide. This
task requires that your computer is already successfully connected to the SAS JBOD.
1. Download Tera Term from https://ttssh2.osdn.jp/index.html.en, and then follow the on-screen
instructions to install the software.
2. Open Tera Term.
The Tera Term: New connection window opens.
3. Click Cancel.
4. Go to Setup > Serial Port .
The Tera Term: Serial port setup and connection window opens.
5. Check the port connection.
a.
Right-click
, and then select Device Manager.
The Device Manager window opens.
b. Click Ports (COM & LPT), and then check the port connected to the SAS JBOD.
6. Select the Port and Speed.
a. Select the port that is connected to the SAS JBOD.
b. Select 115200 as the speed.
Note
Depending on the terminal emulator you use, you may be required to enter the port and speed.
Command-Line Interface User Guide
Accessing the CLI from a Terminal Emulator 3
To Next Page
Loading...
