QNAP SAS JBOD CLI 1.0 - Device Control; Link Rate

Command
counters
Syntax
counters [config | event | reset]
Parameters
Parameter/Value Description
None Display error counters and generic braodcast counters of a physical
layer.
config
Display event configuration of a physical layer.
event
Display event counters of a physical layer.
reset
Reset all counters of a physical layer.
Examples
The following example shows the default output.
Device Control
The CLI commands in this section are related to device commands.
Link Rate
Description
Display the maximum and minimum speed that the SAS JBOD can communicate with other linked devices.
Command-Line Interface User Guide
Conventions and CLI Commands 11