3. Verify that the expansion units are recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
Connecting SATA JBOD Expansion Units
To connect the TS-x32PXU to SATA JBOD expansion units, a host bus adapter must be installed on the
NAS.
For required accessories details, see Installing Expansion Units.
1. Power off the NAS.
2. Install a host bus adapter on the PCIe slot.
Note
The QNAP QXP host bus adapter is required for connecting the SATA JBOD enclosure to a
host device. Third-party host bus adapters are not compatible with QNAP JBOD enclosures.
For details, see Installing Expansion Units.
3. Connect the expansion units to the NAS using the following topology.
Note
This shows the connection between the TL-R400S and the TS-432PXU.
TS-x32PXU User Guide
Installation and Configuration 37
To Next Page
Loading...
Need help?
General
