Reset Button
Operation User Action Result
Basic system reset Press and hold the button for 3
seconds.
The following settings are reset to
default:
• System administrator
password: The default
password is the first MAC
address in uppercase letters
without special characters. For
example, if the first MAC
address is 00-08-9B-F6-15-75,
then the admin password will
be 00089BF61575.
Tip
You can find the first
MAC address using
Qfinder Pro. A label
attached to the device
also lists the address as
MAC1.
• TCP/IP configuration:
• Obtain IP address
settings automatically via
DHCP
• Disable jumbo frames
• If port trunking is enabled
(multi-LAN models only),
the port trunking mode is
reset to “Active Backup
(Failover)”.
• System port: 8080 (system
service port)
• Security level: Low (Allow all
connections)
• LCD panel password: (blank)
• VLAN: Disabled
Advanced system reset Press and hold the button for 15
seconds.
The default factory settings are
restored.
• To retrieve old data after an
advanced system reset,
recreate the previous folder
structure on the NAS.
TS-x32PXU User Guide
Basic Operations 45
To Next Page
Loading...
