QNAP TS-410 User Manual

Chapter 7. Hot-swap Hard Drives
The QNAP NAS is compatible with 2.5-inch/3.5-inch SATA hard disk drives from major hard
disk brands. For the updated hard drive compatibility list, please visit
http://www.qnap.com
.
Caution:
 QNAP disclaims any responsibility for product damage/malfunction or data
loss/recovery due to misuse or improper installation of hard disks in any occasions for
any reasons.
 Note that if a hard drive (new or used) which has never been installed on the NAS
before is installed, the hard drive will be formatted and partitioned automatically and
all the disk data will be cleared.
System Supports
3.5-inch
SATA Hard
Drives
Supports
2.5-inch
SATA Hard
Drives
Supports
SSD
Supports
Hot-swapping
Hard Drives
(RAID 1 or
above only)
TS-110, TS-119, TS-210,
TS-112, TS-212
Yes No No No
TS-119P+, TS-119P II Yes Yes Yes No
TS-219 Yes No No Yes
TS-219P+, TS-419P+,
TS-219P II, TS-419P II,
TS-219P, TS-239 Pro,
TS-239 Pro II, TS-259 Pro,
TS-410, TS-410U, TS-419P,
TS-419U, TS-419U+,
TS-439 Pro, TS-439 Pro II,
TS-239 Pro II+,
TS-439 Pro II+,
TS-439U-RP, TS-439U-SP,
TS-459 Pro,
TS-459U-RP/SP,
TS-459U-RP/SP+,
Yes Yes Yes Yes
38

QNAP TS-410 Specifications

General

CPU	Marvell 6281
CPU Frequency	800 MHz
Flash Memory	16 MB
Drive Bays	4
LAN Ports	1 x Gigabit RJ-45 Ethernet port
Dimensions	177 x 180 x 235 mm
Weight	3.6 kg
Hot Swappable	Yes
RAID Support	RAID 0, 1, 5, 6, JBOD
USB Ports	3 x USB 2.0
eSATA Ports	2
Maximum Internal Raw Capacity	16 TB (4 x 4 TB hard drives)