2. Installation and Conguration
This chapter provides specic hardware and rmware installation and conguration steps.
Hardware Installation
This section provides information on installing drives, memory modules, expansion cards, power supply
units, expansion units, handles, and rail kits.
Installing 2.5-inch Solid-state Drives on 2.5-inch Trays
Warning
• Installing a drive deletes all data on the drive.
• Observe electrostatic discharge (ESD) procedures to avoid damage to components.
•
Moving fan blades: Keep your hands and other body parts away from moving fan
blades.
•
Other moving components: Keep your hands and other body parts away from other
moving components.
Note
The TS-h2490FU is compatible with 2.5-inch U.2 NVMe PCIe solid-state drives, and the
TS-h1090FU is compatible with 2.5-inch U.2 NVMe PCIe solid-state drives and SATA 6 Gbps
solid-state drives.
1. Power o the NAS.
2. Remove the drive tray.
a. Pull the handle to release the tray.
b. Pull the tray out.
TS-hx90FU User Guide
Installation and Conguration 17