QNAP TS-h 90FU Series - Audio Alert

LED Status Description
Drive status Green The drive is ready.
Red A drive read/write error occurred.
Flashes red 5 times per
second
The drive is being located in the operating system.
O No drive was detected.
LAN Orange The network connection is operating.
Flashes orange The device is being accessed from the network.
O The device is not connected to a network.
2.5 Gigabit
Ethernet speed
Green The network connection is operating at 2.5 Gbps.
Orange The network connection is operating at 1 Gbps.
O • The network connection is operating at 10 Mbps.
• There is no network connection.
2.5 Gigabit
Ethernet activity
Orange A network connection has been established.
Flashes orange The device is being accessed from the network.
O There is no network connection.
10 Gigabit
Ethernet
Green The network connection is operating at 10 Gbps.
Flashes green The device is being accessed from a 10 GbE network.
O The device is not connected to a 10 GbE network.
25 Gigabit
Ethernet speed
Green The network connection is operating at 25 Gbps.
Orange The network connection is operating at 10 Gbps or 1 Gbps.
O There is no network connection.
25 Gigabit
Ethernet activity
Orange A network connection has been established.
Flashes orange Data is being transmitted.
O There is no network connection.
Expansion Orange An expansion unit is connected.
O No expansion unit has been detected.
Audio Alert
Duration Frequency Description
Short beep (0.5 seconds) 1 • The NAS is starting up.
• When the reset button is pressed for 3 seconds,
the NAS resets congurations.
• When the reset button is pressed for 10 seconds,
the NAS resets congurations and reboots.
• The operating system was updated.
3 • Cannot detect installed disk.
TS-hx90FU User Guide
Basic Operations 56