QOLSYS CONFIDENTIAL AND PROPRIETARY
PAGE OF 12 197
Press and hold the power button on
the right side of the panel for 3
seconds to power up.
Connect power supply.
WARNING! Use included 7v⎓DC Power Supply ONLY
If using the provided cable, the “striped” wire is (+)
Note: Power supply shall be located within same room as control unit
Note: This unit must be powered by a 24-hour, 120 V, 60 Hz or 230-240 VAC, 50 Hz circuit (as appropriate for your country) that cannot be turned off by
a switch, dimmer, or Residual Current Device. Failure to provide this circuit may prevent it from providing constant protection. Power supply shall be
located within same room as control unit.
To Next Page
Loading...
Need help?
General
