35
TD-000472-00-B
Input Channel – Pitch Correct
Pitch Correct (available on Input channels 1 through 16) shifts the frequency of an input signal to match the nearest “correct” musical pitch. The mixer
has only one Pitch Corrector which can be assigned to only one channel at a time.
IMPORTANT:
You can enable or disable the Pitch-Correct feature using User Buttons without regards to the position of the Enable
button on this screen. If you don’t hear any difference with Pitch Correct enabled, check to make sure the feature has not been disabled
using the User Button feature. Refer to User Buttons on page 57.
Home
Select
Input Bank
Select Input
Channel
FXIn 2
Inputs 1-8
Select
FX
Refer to — Figure 25
1.
Pitch Correct Enable Button
– Assigns and enables/disables Pitch Correct to the
currently selected channel.
2.
Blend Knob
– Sets the ratio of uncorrected (Dry) to corrected (Wet) signal. When fully
clockwise, only corrected signal will be heard. When fully counter clockwise, only the
original signal will be heard. Intermediate settings will result in a doubling effect.
3.
Key Knob
– Selects a key for the pitch corrector to use in determining what the target
note is. If “None” is selected, the Pitch Corrector will target the nearest chromatic pitch.
The table shows the Key selections.
4.
Correct Rate Knob
– determines how quickly the pitch is corrected
— Figure 25 —
1
None E A
C F
A/B
C/D F/G
B
D G
D/E G/A
To Next Page
Loading...
