QSC TouchMix Series - QSC NXD Amplifier Settings; Aux Overview; Output Channel - QSC NXD Amplifier Settings

45
TD-000472-00-B
Output Channel – QSC GXD Amplifier Settings
Provides information for properly adjusting QSC GXD Amplifiers when used with the TouchMix.
Home Select the
Aux Bank
Touch a
Select Button
Select
Setup Tab
Setup
Aux Outputs
Aux 1 Main
or
GXD Amp Settings
Touch GXD
Amp Settings
Refer to — Figure 39
On the GXD Amplifier:
1.
Home – If the amplifier’s Gain screen is not displayed, press the Home button. If the Gain screen is
displayed, skip to the next step.
2. Adjust the Gain A and Gain B knobs for 0.0 dB gain. Enter – Moves to the next screen.
3. Adjust the Gain B/DSP Control knob to select Stereo DSP. Enter – Moves to the next screen.
4. Adjust the Gain B/DSP Control knob to select Sensitivity. Enter – Moves to the next screen.
5. Adjust the Gain B/DSP Control knob to select TouchMix. Enter – Confirms selection.
6. Home – Returns to the Home screen.
On the TouchMix:
7. Done – Closes the GXD Amp Settings pop-up.
Aux Overview
Provides an overview of Aux Sends for all Input channels and FX Mixes, along with the Aux
Master faders for each Aux mix.
All aux sends, pan controls, and master fader levels may be adjusted by touching to select and using the Master Encoder.
Menu Press
Aux Overview
Select an
Input Bank
Menu
Aux
Overview
Inputs 1-8
Refer to — Figure 40
1. Only Input and FX Master banks are selectable on the Nav Strip while in
the Aux Overview.
2. Each column (In 1, In 2) represents a channel, and lists the channel’s Aux
Sends and pan controls.
NOTE: If an input has been given a name, the name will be
displayed as the column heading. Touch the Select (name) button
to navigate to the input channel’s controls.
3. Each row represents an Aux mix , the name of the mix is displayed in the
first column and with the Master fader.
4. Pre Fdr/ Post Fdr / Pre Dyn / Pre All – Indicates the Aux Pick-off point
for the selected Aux mix. You can change the setting by going to the Aux
Channel Setup tab.
5. Aux Master Fader – Adjusts the overall level of the mix.
6. Stereo Aux Master Slider – A single slider is provided for a stereo pair.
7. Pan Control Slider – Pans the input between the left and right sides of a
stereo aux mix.
NOTE: If an Aux output is given a user defined name, that name will be displayed above the Aux Master.
— Figure 39 —
1
7
2
3
4
5
6
— Figure 40 —
1
6
2
3
4
5
7