QSC TouchMix Series - FX Masters; FX Masters - Effect; FX Masters - EQ

46
TD-000472-00-B
FX Masters
FX Masters – Effect
FX controls common to all Effects Processors. Refer to the individual FX Processor topics for details.
Home Select the FX
Masters Bank
Touch a
Select Button
Select
Effect Tab
Eect
FX Masters
FX 1
Refer to — Figure 41
1. Effect Tab – Selects the FX Master Effect screen
2. Aux Send Knobs (TouchMix-16,, 1–10) (TouchMix-8, 1–4) – Adjust level of processed
audio going to the Aux mixes.
3. Reset Button – Returns processor and Aux Send controls to their default settings.
4. Preset Label – Name of the current preset. Touch to access the library of Presets.
5. FX Pull-down – Touch to select a different processor.
6. Simple Button – Turns Simple mode on and off. Hides all but the essential controls on
the selected FX. The hidden controls are unique to the selected FX device. The Mono and
Stereo Delays do not have a Simple mode.
7. Meters – The Input meter displays the incoming audio level before the FX. The Output
meters display the stereo audio level after the FX.
8. FX Master Fader – Controls the level of the FX mix to the Main L/R Outputs. Select Pre-
fader Listening (PFL) or After-Fader Listening (AFL) on the Mixer Setup screen.
FX Masters – EQ
Controls and displays the settings for the FX Master channel equalization.
Home Select the FX
Masters Bank
Touch a
Select Button
Select
EQ Tab
EQ
FX Masters
FX 1
Refer to — Figure 42
1. EQ Tab – Selects the FX Master EQ screen.
2. EQ Graph – A graphic representation of the EQ settings. The vertical measurement is
gain, the horizontal is frequency. In the example, the Low Cut filter and the high Shelf
filter are engaged.
3. Shelf Filter Buttons – 1 (low), 2 (high) – Engages / disengages the associated shelf
filter.
4. Low Cut Button – Engages/disengages the low cut filter. This filter cuts frequencies
below the frequency set by the Freq control.
5. Gain Knob – Adjusts the gain of the associated EQ band over a range of -15 dB to +15
dB.
6. Frequency Knob – Sets the frequency at a point 3 dB below 0 for the Low Cut filter and
3 dB above (when gain is negative) or below (when gain is positive) the Gain setting of
the associated Shelf Filter.
7. EQ In Button – Engages the equalizer
8. Reset Button – Sets all the EQ controls to their factory default position.
— Figure 41 —
1
6
2
8
5
4
3
7
— Figure 42 —
1
3
2
5
8
4
6
7