3. To print the imprint, insert the mail piece into the base against the rear-guide wall,
with the side to be printed facing upwards.
If a mail piece is bigger than mail path maximum thickness,
press to print a label. The label is printed. To know the
maximum thickness, see Mail Specifications on page 225.
4. The Mailing System applies postage and the mail piece (or label) is sent to the catch
tray.
When sealer is activated, collect the mail piece stack in the catch
tray and put stack aside to let envelopes dry.
5. Repeat the previous step for each piece of mail.
To quit the process at any time, press .
When you remove the last object from the Weighing Platform,
the Mailing System will ask if you want to print it. You can answer
Yes or No.
In optional mode Differential Weighing Automatic Label ( ):
From the [Normal] home screen:
1. Place the stack of mail you to process on the weighing platform, and then follow the
instructions on the screen or the steps below.
3
Processing Mail
47
| Page 47 | Jul-31-2018 12:32 |
To Next Page
Loading...
Need help?
General
