Q24/Q48 Tape Library Installation and Operations Manual
2.5 Unpacking the library
Before unpacking the library, clear a work surface on which to place the unpacked components. If the
library will be installed in a rack, select an open rack location allowing easy access to the host server
and an easily accessible power outlet.
If the temperature in the room where the library will be
installed varies by 15° C (30° F) or more from the room where
the library was stored, allow the library to acclimate to the
surrounding environment for at least 12 hours before unpacking
it from the shipping container.
1. Before opening and removing the tape library from the box, inspect the container for shipping
damage. If you notice any damage, report it to the shipping company immediately.
2. Open the box.
3. Carefully remove the shipping materials from the top of the library.
4. Remove the accessory package and set aside (if included).
5. Remove the two rack rails and set aside (if included).
6. Lift the library out of the carton and remove the bag from the loader. Save the packaging
materials for future use.
Do not place the library on either end or sides as this may
damage it.
2.6 Identifying the product components
Confirm that you received the following:
1. Q24/Q48 Tape Library, including power supply, 1 or more half-height tape drives (as ordered),
library controller, and two tape magazines for the Q24, or four magazines for the Q48.
2. Rack mount kit:
- 2 rack mount rails
- 1 bag of eight M6 screws for the rack mounting (9.5 mm square holes in the rack column)
- 1 bag of eight M6 screws for rack mounting (6.85 mm round holes in the rack column)
- 2 mounting brackets
- T10 Torx screws to attach the mounting brackets
- M5 screws to secure the mounting brackets to the rack
3. Power cord
4. Library documentation
Optional components, depending on the purchased configuration:
1. Cables - for instance Fibre Channel and SAS cables
© Copyright QUALSTAR 2015 12
To Next Page
Loading...
Need help?
General
