Need help?Do you have a question about the Qualstar Q40 and is the answer not in the manual?
General| Type | Tape Library |
|---|---|
| Drive Bays | 4 |
| Max Tape Drives | 4 |
| Form Factor | Rackmount |
| Interface | SAS |
Emphasizes that only trained personnel should operate the library equipment.
Outlines planning steps and specifies environmental/physical requirements for installation.
Details requirements for SAS and Fibre Channel connections, HBAs, and cable types.
Guides on planning module arrangement and preparing the host computer.
Provides safety precautions for installation and details module unpacking procedures.
Guides on aligning modules, connecting drives, and connecting cables.
Covers library power-on, initial setup wizard, and host connection verification.
Provides instructions for logging into the library via OCP and RMI.
Guides on using the OCP wizard for initial library setup.
Guides through initial system setup including network, date/time, and PIN.
Covers saving, restoring, and resetting library configuration settings via RMI.
Guides on configuring network settings, unlabeled media, and SNMP.
Explains mailslot, partition, and user account configuration procedures.
Details installing tape drives and connecting SAS cables.
Guides on replacing power supplies and controller boards.
Provides an overview of module replacement, configuration saving, and component removal.
Explains removing and installing the robotic assembly and spooling mechanism.
Details how to remove and install the front bezel or Operator Control Panel.
Addresses RMI connection problems, cleaning issues, and performance optimization.
To Next Page
