Q24/Q48 Tape Library Installation and Operations Manual
3.4 Default settings
Setting Default for the library
Initial admin password adm001
Host name
FLX + last 6 characters of MAC address
e.g. MAC = 000E11801907, host name = FLX801907
Domain name localdomain.com
IPv4 Enabled
IPv6 Disabled
DHCP Disabled
Mail slot configuration Disabled
Configure reserved slots Reserved slots = 0
SCSI master drive The lowest physical drive is initially the LUN master drive.
OCP contrast setting 10
Library Mode Automatic
Auto load Disabled
Loop Disabled
Drive power <ON/OFF> All drives are powered <ON>
Auto clean Disabled
FC tape drives Automatic speed, auto topology
Log Tracing Configuration All selected
Email notification No events
Partitioning Partitioning is turned <OFF>
Table 5 Default settings
© Copyright QUALSTAR 2015 64
To Next Page
Loading...
Need help?
General
