Q24/Q48 Tape Library Installation and Operations Manual
3.2 Remote management unit (RMU)
3.2.1 Overview
Many of the same operations performed locally from the operator control panel (OCP) can also be
performed remotely using the network connected Remote Management Unit (RMU).
The RMU lets you monitor and control the library from any computer connected to your network or
through the World Wide Web (WWW). The RMU hosts a dedicated, protected Internet site that
displays a graphical representation of the library.
After establishing a network connection to the library, open any HTML browser and enter the IP
address of the library. To allow access from the RMU, you must first set the desired static IP address at
the OCP or configure to use DHCP.
3.2.2 Operations through the RMU
The following operations are available through the remote management unit as explained below:
1. Identity
• Viewing the static library identity
• Viewing the static drive identity
• Viewing the network identity
2. Status
• Viewing the dynamic library status
• Viewing the dynamic drive status
• Viewing the tape cartridge inventory
3. Configuration
• Changing the system configuration
• Changing the logical library configuration
• Setting the license key
• Changing the drive configuration
• Changing the network configuration
• Changing the SNMP configuration
• Changing the user password
• Setting date/time
• Setting error log mode
• Setting event for email notification parameters
• Restoring factory defaults
© Copyright QUALSTAR 2015 35
To Next Page
Loading...
Need help?
General
